g3 tightbore

Sgt.Cracker · 11-10-2005, 07:41 PM

im getting a tightbore for my g3sas. 6.04 systema would any know how to put this in to replace my old one?

Sgt.Cracker · 11-11-2005, 07:05 AM

any one? i need to put it in before the big game. ill look around.

**WWIII_USMC** · 11-11-2005, 10:56 AM

ummm...whats the point. With the short length of the SAS barrel it wouldn't make much of a difference. It would be a waste of money in my opinion.

**Rjaniz** · 11-11-2005, 12:17 PM

Read your manual. It's a TM gun, there is a rudementary dissembly diagram in the back of its manual.

**Therabbit** · 11-11-2005, 01:25 PM

Remove pins, slide rear lower receiver backwards and off, tilt, inner barrel will fall out the back with the hopup. Disassemble [the hopup] and place new barrel [in the hopup], then repeat in reverse. I also second the why question though. (This post has been edited by the grammar police. Thank you for your time, you will receive a bill in the mail within 4-8 months once we believe you've forgotten about this.)

Freakin grammer police, they always pull me over mid-sentence.

Sgt.Cracker · 11-11-2005, 03:53 PM

ok thx